Operator's Guide Imprinter fi-565PR

fi-565PR Imprinter Operator’s Guide | 5

2. Installation

2.1. Installing the Imprinter

Install the imprinter as follows:

1. Switch off the Scanner and disconnect the

electrical power cable.

2. Remove the Stacker from the scanner.

c Lift the Stacker about 45°.

d At the end of the Stacker, where attached to the scanner,

press down on the lower center of the Stacker to release it

and gently pull the Stacker away.

3. Remove the cover (black) located under the

stacker.

ATTENTION

You must remove the stacker and black cover

before installing the Imprinter to the Scanner.

4. Install the Imprinter to the Scanner.

c Check the insertion direction of the Attachment Guide.

d Check the Shaft from below.

e Locate the Attachment Guide along the Shaft.

f Push up the Attachment Guide.

Attachment Guide

ADF

Shaft

Scanner

ADF