CLI Guide

tcp Enter the keyword tcp to congure a TCP access list lter.
udp Enter the keyword udp to congure a UDP access list lter.
source Enter an IP address in dotted decimal format of the network from which the packet was
received.
mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when
specied in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address or
hostname.
operator (OPTIONAL) Enter one of the following logical operands:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
parameter.)
port port (OPTIONAL) Enter the application layer port number. Enter two port numbers if you are
using the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have the
lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which the ACL logs must be generated. The interval range is from 1 to 10 minutes.
Access Control Lists (ACL) 177