CLI Guide

show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the system returns No Active VRRP
group.
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identifier for the VRRP
group to view only that group. The range is from 1 to 255.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For Port Channel interface types, enter the keywords
port-channel then the number. The range is from 1 to
128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show vrrp brief command shown in the following
example.
Item Description
Interface Lists the interface type, slot and port on which the VRRP
group is configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface. If the
track command is configured to track that interface and
the interface is disabled, the cost is subtracted from the
priority value assigned to the interface.
Pre States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
Virtual Router Redundancy Protocol (VRRP)
1541