Service Manual

Related Commands
rate-police — specifies traffic policing on the selected interface.
rate shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands rate-shape — shapes traffic output as part of the designated policy.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command.
The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
Quality of Service (QoS) 1001