Service Manual

NOTE: Only one of the IP precedence values must be a successful match criterion, not all of the
specified IP precedence values must match.
Related Commands class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match criteria in the class map.
Defaults none
Command Modes CLASS-MAP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria.
Related Commands class-map — identifies the class map.
match mac dot1p
Configure a match criterion for a class map based on a dot1p value.
Syntax
match mac dot1p {dot1p-list}
Parameters
dot1p-list Enter a dot1p value. The range is from 0 to 7.
Defaults none
Command Modes CLASS-MAP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria.
Related Commands class-map — identifies the class map.
Quality of Service (QoS) 1011