Service Manual

match mac vlan
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
number Enter the VLAN ID. The range is from 1 to 4094.
Defaults none
Command Modes CLASS-MAP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To access this command, enter the class-map command. You can match against only one VLAN ID.
Related Commands class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (input/output)
applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If the rate shape exists in both aggregate and per-queue qos-policy, minimum of two take effect. Some of all
Queue-rate will not exceed aggregate.
Related Commands
policy-map-output — creates an output policy map.
1012 Quality of Service (QoS)