Service Manual

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables Policy-
Map-Output Configuration mode (conf-policy-map-out).
Related Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use the no qos-policy-input qos-policy-name
[layer2] command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32 characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The default is
Layer 3.
Defaults Layer 3
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the input QoS policy, use this command. After the input policy is specified, rate-police is
defined. This command enables Qos-Policy-Input Configuration mode — (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules are deleted and re-added
automatically to ensure that the order of the rules is maintained. As a result, the Matched Packets value shown in
the show qos statistics command is reset.
Related Commands rate police — incoming traffic policing function.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
1014 Quality of Service (QoS)