Service Manual

To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the output QoS policy, use this command. After the output policy is specified, rate shape,
scheduler strict, bandwidth-percentage, and WRED can be defined. This command enables Qos-Policy-Output
Configuration mode — (conf-qos-policy-out).
Related Commands
bandwidth-percentage — assigns weight to the class/queue percentage.
rate police
Police the incoming traffic rate on the selected interface.
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is
100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.
The range is from 0 to 10000. The default is the same as designated for committed-
rate
.
Defaults Burst size is 100 KB. peak-rate is the same as committed-rate. Granularity for committed-rate and
peak-rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Quality of Service (QoS) 1015