Service Manual

Parameters
queue-id Enter the value used to identify a queue. The range is from 0 to 3 (four queues per
interface; four queues are reserved for control traffic).
class-map class-
map-name
(OPTIONAL) Enter the keyword class-map then the class map name assigned to the
queue in character format (32 character maximum).
NOTE: This option is available under policy-map-input only.
qos-policy qos-
policy-name
(OPTIONAL) Enter the keywords qos-policy then the QoS policy name assigned to
the queue in text format (32 characters maximum). This specifies the input QoS policy
assigned to the queue under policy-map-input and output QoS policy under
policy-map-output context.
Defaults none
Command Modes CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information There are four queues per interface on the MXL switch. This command assigns a class map or QoS policy to
different queues.
Related Commands
service-policy output — applies an output policy map to the selected interface.
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP value. The range is from 0
to 63.
mac-dot1p value Enter the keywords mac-dot1p then the dot1p value. The range is from 0 to 7.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
1018 Quality of Service (QoS)