Service Manual

Defaults none
Command Modes CONFIGURATION (conf-policy-map-in)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you configure trust, matched bytes/packets counters are not incremented in the show qos
statistics command.
Dynamic mapping honors packets marked according to the standard definitions of DSCP. The following lists the
default mapping.
Table 2. Default Mapping
DSCP/CP hex
Range (XXX)
DSCP Definition Traditional IP
Precedence
MXL Switch
Internal Queue ID
DSCP/CP Decimal
111XXX Network Control 3 48–63
110XXX Internetwork
Control
3 48–63
101XXX EF (Expedited
Forwarding)
CRITIC/ECP 2 32–47
100XXX AF4 (Assured
Forwarding)
Flash Override 2 32–47
011XXX AF3 Flash 1 16–31
010XXX AF2 Immediate 1 16–31
001XXX AF1 Priority 0 0–15
000XXX BE (Best Effort) Best Effort 0 0–15
wred
Designate the WRED profile to yellow or green traffic.
Syntax
wred [[{yellow | green} profile-name] ecn]
To remove the WRED drop precedence, use the no wred {yellow | green} [profile-name]
command.
Parameters
yellow | green Enter the keyword yellow for yellow traffic. A DSCP value of xxx110 and xxx101 maps
to yellow.
Enter the keyword green for green traffic. A DSCP value of xxx0xx maps to green.
profile-name
Enter your WRED profile name in character format (16 character maximum). Or use one
of the five pre-defined WRED profile names.
1026 Quality of Service (QoS)