Service Manual

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To redistribute the default route (0.0.0.0/0), configure the default-information originate command.
Related Commands
default-information originate — generates a default route for RIP traffic.
redistribute ospf
Redistribute routing information from an OSPF process.
Syntax
redistribute ospf process-id [match external {1 | 2} | match internal | metric
metric-value] [route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match external {1 | 2}
| match internal | metric metric-value] [route-map map-name] command.
Parameters
process-id Enter a number that corresponds to the OSPF process ID to redistribute. The range is
from 1 to 65355.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external then the numbers 1 or 2 to
indicated that external 1 routes or external 2 routes should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to indicate that internal routes
should be redistributed.
metric metric-value (OPTIONAL) Enter the keyword metric then a number as the metric value. The range
is from 0 to 16.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a configured route map.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
router rip
To configure and enable RIP, enter ROUTER RIP mode.
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
1044 Routing Information Protocol (RIP)