Service Manual

Parameters
priority-value Enter a number as the bridge priority value in increments of 4096. The range is from 0 to
61440. The default is 32768.
Defaults Disabled
Command Modes CONFIGURATION (conf-rstp)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no disable
command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related Commands disable — disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-rstp)#show config
!
protocol spanning-tree rstp
1064 Rapid Spanning Tree Protocol (RSTP)