Service Manual

ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16838.
• For the Null interface, enter the keywords null 0.
•
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
radius-server deadtime
Configure a time interval during which non-responsive RADIUS servers to authentication requests are skipped.
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, use the no radius-server deadtime command.
Parameters
seconds Enter a number of seconds during which non-responsive RADIUS servers are skipped.
The range is from 0 to 2147483647 seconds. The default is 0 seconds.
Defaults 0 seconds
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Security 1091