Service Manual

Defaults 20 seconds
Command Modes CONFIGURATION
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The polling interval for an interface is the maximum number of seconds between successive samples of counters
sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can
configure an interface to use a different polling interval.
sflow polling-interval (Interface)
Set the sFlow polling interval at an interface (overrides the global-level setting).
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to 86400 seconds. The default is
the global counter polling interval.
Defaults The same value as the current global default counter polling interval.
Command Modes INTERFACE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command sets the counter polling interval for an interface.
Related Commands sflow polling-interval (Global) — globally sets the polling interval.
sflow sample-rate (Global)
Change the global default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. The range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, 16384, and so on. The default is 32768
packets.
Defaults 32768 packets
Command Modes CONFIGURATION
Command History
Version Description
1130 sFlow