Service Manual

• EXEC Privilege
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The dropEvent counter (sFlow samples dropped due to sub-sampling) shown in the following example always
displays a value of zero.
Example
Dell#show sflow
sFlow services are enabled
Egress Mangement Interface sFlow services are disabled
Global default sampling rate: 2048
Global default counter polling interval: 20
Global extended information enabled: none
0 collectors configured
0 UDP packets exported
0 UDP packets dropped
0 sFlow samples collected
stack-unit 0 Port set 0
Te 0/1: configured rate 256, actual rate 256
Dell#
Dell#show running-config sflow
!
sflow enable
sflow sample-rate 2048
Dell#show running-config interface tengigabitethernet 0/1
!
interface TenGigabitEthernet 0/1
no ip address
sflow enable
sflow sample-rate 256
no shutdown
show sflow stack-unit
Display the sFlow information on a stack unit.
Syntax
show sflow stack-unit {unit number}
Parameters
unit number (OPTIONAL) Enter a unit number to view information on the stack unit in that slot. The
range is from 0 to 5.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The dropEvent counter (sFlow samples dropped due to sub-sampling) shown in the following example below
always displays a value of zero.
1132 sFlow