Service Manual

protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specific value.
Syntax
protocol-tunnel destination-mac xstp address
Parameters
stp Change the default destination MAC address used for L2PT to another value.
Defaults The default destination MAC is 01:01:e8:00:00:00.
Command Modes CONFIGURATION
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable VLAN-Stacking, no protocol packets are tunneled.
Related Command show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The system must have the default CAM profile with the default microcode before you enable L2PT.
protocol-tunnel rate-limit
Enable traffic rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to 3000. The default is 75.
Defaults 75 frames per second.
Command Modes CONFIGURATION
1136 Service Provider Bridging