Service Manual

• logging facility
• logging history
• logging history size
• logging monitor
• logging on
• logging source-interface
• logging synchronous
• logging trap
• logging version
• show logging
• show logging driverlog stack-unit
• show logging auditlog
• terminal monitor
SNMP Commands
The following SNMP commands are available in the Dell Networking OS.
The simple network management protocol (SNMP) is used to communicate management information between the network management
stations and the agents in the network elements. The system supports SNMP versions 1, 2c, and 3, supporting both read-only and read-
write modes. The system sends SNMP traps, which are messages informing an SNMP management system about the network. The
system supports up to 16 SNMP trap receivers.
Important Points to Remember
• Typically, 5-second timeout and 3-second retry values on an SNMP server are sufficient for both local area network (LAN) and wide
area network (WAN) applications. If you experience a timeout with these values, the recommended best practice on Dell Networking
switches (to accommodate their high port density) is to increase the timeout and retry values on your SNMP server to the following:
• SNMP Timeout — greater than 3 seconds.
• SNMP Retry count — greater than 2 seconds.
• If you are using access control lists (ACLs) in an SNMP v3 configuration, group ACL overrides user ACL if the user is part of that
group.
• SNMP operations are not supported on a virtual local area network (VLAN).
clear logging auditlog
Clears audit log.
Syntax
clear logging auditlog
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Simple Network Management Protocol (SNMP) and Syslog 1139