Service Manual

* Management Unit
-- Thermal Sensor Readings (deg C) --
Unit Sensor0 Sensor1
---------------------------
1 39 41
--------------------- show ip traffic -------------------
IP statistics:
Rcvd: 894390 total, 415557 local destination
0 format errors, 0 checksum errors, 0 bad hop count
0 unknown protocol, 0 not a gateway
15 security failures, 0 bad options
Frags: 0 reassembled, 0 timeouts, 0 too big
0 fragmented, 0 couldn't fragment
Bcast: 402 received, 0 sent; Mcast: 37 received, 0 sent
Sent: 468133 generated, 0 forwarded
42 encapsulation failed, 0 no route
ICMP statistics:
Rcvd: 0 format errors, 0 checksum errors, 0 redirects, 2 unreachable
0 echo, 0 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp, 0 info request, 0 other
Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 info reply, 0 time exceeded, 0 parameter problem
UDP statistics:
Rcvd: 396516 total, 0 checksum errors, 0 no port
0 short packets, 0 bad length, 28746 no port broadcasts, 0 socket full
Sent: 16460 total, 28746 forwarded broadcasts
TCP statistics:
Rcvd: 4618 total, 0 checksum errors, 0 no port
Sent: 5023 total
ARP statistics:
Rcvd: 43988 requests, 24518 replies, 10 wrong interface
Sent: 42 requests, 6 replies (0 proxy)
Related Commands
show version — Displays the Dell Networking OS version.
show system — Displays the current switch status.
show environment — Displays the system component status.
show processes memory — Displays memory usage based on running processes.
telnet
Connect through Telnet to a server. The Telnet client and server in the Dell Networking Operating System (OS) support IPv4 connections.
You can establish a Telnet session directly to the router or a connection can be initiated from the router.
Syntax
telnet {host | ip-address} [/source-interface]
Parameters
host Enter the name of a server.
ip-address Enter the IPv4 address in dotted decimal format of the server.
source-interface (OPTIONAL) Enter the keywords /source-interface then the interface information
to include the source interface. Enter the following keywords and slot/port or number
information:
116 Control and Monitoring