Service Manual

show storm-control unknown-unicast
Display the storm control unknown-unicast configuration.
Syntax
show storm-control unknown-unicast [interface]
Parameters
interface (OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Example
Dell#show storm-control unknown-unicast tengigabitethernet 3/1
Unknown-unicast storm control configuration
Interface Direction Packets/Second
----------------------------------------
TenGig 3/1 Ingress 1000
Dell#
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second in]
command.
Parameters
packets_per_secon
d
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
Version Description
1178 Storm Control