Service Manual

storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d
Enter the packets per second of multicast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Broadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when
storm control thresholds are exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on the switch interface (ingress only).
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed on the switch (ingress rate only).
Syntax
storm-control unknown-unicast [packets_per_second in]
1180 Storm Control