Service Manual

9.9(0.0) Introduced on the FN MXL.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree stp-id command.
Parameters
stp-id Enter zero (0). The system supports one spanning tree group, group 0.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the no
disable command from SPANNING TREE mode.
Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related Commands disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable command.
show config
Display the current configuration for the mode. Only non-default values display.
Syntax
show config
Command Modes SPANNING TREE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
1186 Spanning Tree Protocol (STP)