Service Manual

Example
BOOT_USER # help
***** Dell Force10 Boot Interface Help Information *****
Current access level: USER LEVEL
Use "syntax help" for more information on syntax.
Available command list (22 commands total):
boot change [primary|secondary|default]
change operating system boot parameters
boot selection [a|b]
change the rom bootstrap bootflash partition
boot show net config retries
show number of retries for network boot config failure
boot write net config retries <int>
write number of retries for network boot config failure
boot zero [primary|secondary|default]
zero operating system boot parameters
default-gateway <ip-address>
default-gateway - set the default gateway ip address
enable [user|admin]
change access privilege level
help
display help menu
-(36%)-Use <CR> to continue, q to stop:
BOOT_USER #
ignore enable password
Ignore the enabled password.
Syntax
ignore enable-password
Command Modes uBoot
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
enable sha256-password
Configure SHA-256 based password for the enable command.
Syntax
enable sha256-password [level level] [encryption-type] password
To delete a password, use the no enable sha256-password [encryption-type] password
[level level] command.
Parameters
sha256-password Enter the keyword sha256-password then the encryption-type or the password.
level level (OPTIONAL) Enter the keyword level then a number as the level of access. The range
is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 8 or 0 as the encryption type.
Enter 8 to enter the sha256–based hashed password.
password Enter a text string, up to 32 characters long, as the clear text password.
1236 u-Boot