Service Manual

• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
enable
Re-enable upstream-link tracking for an uplink-state group after it has been disabled.
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the no enable command.
Parameters
group-id Enables debugging on the specified uplink-state group. The valid group-id values are from
1 to 16.
Defaults Upstream-link tracking is automatically enabled in an uplink-state group.
Command Modes UPLINK-STATE-GROUP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
show running-config uplink-state-group
Display the current configuration of one or more uplink-state groups.
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current configuration of all uplink-state groups or a specified group. The valid
group-id values are from 1 to 16.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show running-config uplink-state-group
!
uplink-state-group 3
no enable
description Testing UFD feature
downstream disable links 2
downstream TenGigabitEthernet 0/1-2,5,9,11-12
upstream TenGigabitEthernet 0/3-4
Uplink Failure Detection (UFD) 1247