Service Manual

Parameters
ip–address Enter the IPv4 or IPv6 address of the backup destination.
interval seconds Enter the keyword interval to specify the time interval to send hello messages. The
range is from 1 to 5 seconds. The default is 1 second.
Defaults Not configured.
Command Modes VLT DOMAIN
Usage Information You can only enable either IPv4 or IPv6.
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,
use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-address]
Enter the multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ip pim tib
Clear PIM tree information from the PIM database.
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you use this command on a local VLT node, all multicast routes from the local PIM TIB, the entire multicast route
table, and all the entries in the data plane are deleted. The entries in Peer PIM TIB (Sync) are not deleted but are
1260 Virtual Link Trunking (VLT)