Service Manual

marked for re-download. Both local and synced routes are removed from the multicast route table. The peer VLT
node clears synced routes from the node.
If you use this command on a peer VLT node, only the synced routes are deleted from the multicast route table.
delay-restore abort-threshold
Increase the Boot Up timer to some value (>60 seconds).
Syntax
delay-restore abort-threshold <interval>
To remove use the no delay-restore abort-threshold command.
Defaults 60 seconds
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on Supported on the MXL 10/40GbE Switch IO Module.
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to abort. This timer is applicable
only during reload/boot-up and not in other scenarios (example, ICL flap).
The range is from 1 to 1800 seconds.
Usage Information To abort VLT delay restore timer as the maximum threshold, the maximum time interval is applied to hold down
ICL peer-up in the start-up configurations during the reload.
lacp ungroup member-independent vlt
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent vlt
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
LACP on the VLT ports (on a VLT switch or access device), which are members of the virtual link trunk, is not
brought up until the VLT domain is recognized on the access device.
Virtual Link Trunking (VLT) 1261