Service Manual

multicast peer-routing timeout
Configure the time for a VLT node to retain synced multicast routes or synced multicast outgoing interface (OIF) after a VLT peer node
failure.
Syntax
multicast peer-routing timeout value
To restore the default value, use the no multicast peer-routing timeout command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to 1200. The default is 150.
Default Not configured.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-link port-channel
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel id-number
Parameters
id-number Enter the port-channel number that acts as the interconnect trunk. The range is from 1
to 128.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing
Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
Version Description
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
1262 Virtual Link Trunking (VLT)