Service Manual

Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you do not specify options, debug is active on all interfaces and all VRRP groups.
description
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
Defaults Not enabled.
Command Modes VRRP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Defaults Enabled.
Command Modes VRRP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command and
enter no disable.
Related Commands virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the
new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
1276 Virtual Router Redundancy Protocol (VRRP)