Service Manual

To return to the default value, use the no hold-time command.
Parameters
seconds Enter a number of seconds. The range is from 0 to 65535. The default is zero (0)
seconds.
centisecs centisecs Enter the keyword centisecs then the number of centisecs in units of 25 centisecs.
The range is from 0 to 65525 in units of 25 centisecs.
Defaults zero (0) seconds
Command Modes VRRP
Command History
Version Description
9.5(0.0) Introduced the support for centisecs on the MXL 10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP for the new hold timer value
to take effect.
Related Commands disable — disables a VRRP group.
preempt
To preempt or become the MASTER router, permit a BACKUP router with a higher priority value.
Syntax
preempt
To prohibit preemption, use the no preempt command.
Defaults Enabled (that is, a BACKUP router can preempt the MASTER router).
Command Modes VRRP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER election process.
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority Enter a number as the priority. Enter 255 only if the router’s virtual address is the same
as the interface’s primary IP address (that is, the router is the OWNER). The range is
from 1 to 255. The default is 100.
Defaults 100
Command Modes VRRP
Virtual Router Redundancy Protocol (VRRP) 1277