Service Manual

Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with same IP
address as the interface’s primary IP address and change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the interface’s primary IP
address, an error message appears.
NOTE: Configuring VRRP priority 255 on an interface on which DHCP Client is enabled is not
supported.
show config
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Command Modes VRRP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the system returns No Active VRRP group.
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that
group. The range is from 1 to 255.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
1278 Virtual Router Redundancy Protocol (VRRP)