Service Manual

Defaults Not configured.
Command Modes VRRP
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you
delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with the same IP
address as the interface’s primary IP address and change the priority of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP initialization after an interface
becomes operational. The range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command applies to a single interface. When used with the vrrp delay reload CLI, the later timer rules
the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are
up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
Related Command vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
1282 Virtual Router Redundancy Protocol (VRRP)