Service Manual

Parameters
seconds Enter the number of seconds for the delay. The range is from 0 to 900 (0 indicates no
delay).
Defaults 0
Command Modes INTERFACE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command applies to all the VRRP configured interfaces on a system. When used with the vrrp delay
minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the
vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are
up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
Save the configuration and reload the system for the delay timers to take effect.
Related Command vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you
delete the virtual address, the VRRP group stops sending VRRP packets.
Related Command virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
VRRP for IPv6 Commands
The following commands apply to IPv6.
Virtual Router Redundancy Protocol (VRRP)
1283