Service Manual

clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255.
vrf instance (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear the
counters of all IPv6 VRRP groups in the specified VRF.
Defaults Not configured
Command Modes INTERFACE
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports.
• You can specify multiple ports as slot/port-range. For example, if you want to clear the port configurations
corresponding to all ports between 1 and 4, specify the port range as clear counters
interfacesinterface-type 1/1 - 4.
debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
1284 Virtual Router Redundancy Protocol (VRRP)