Service Manual

Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the system returns No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only that
group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For SONET interfaces, enter the keyword sonet then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show vrrp ipv6 command shown in the following example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address. If the interface is no
sending VRRP packets, 0.0.0.0 appears as the network address.
VRF VRF instance to which the interface (on which the VRRP group is configured) belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Virtual Router Redundancy Protocol (VRRP) 1285