Service Manual

• Keepalive: enable
• Vlan priority: 3
Command Modes CONFIGURATION
INTERFACE
Command History
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
An FCoE map is a template used to map FCoE and FC parameters in a converged fabric. An FCoE map is used to
virtualize upstream FC ports on an M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
NPIV proxy gateway so that they appear to downstream server CNA ports as FCoE forwarder (FCF) ports on an
FCoE network. When applied to FC and Ethernet ports on an NPIV proxy gateway, an FCoE map allows the
switch to operate as an FCoE-FC bridge between an FC SAN and an FCoE network by providing FCoE-enabled
servers and switches with the necessary parameters to log in to a SAN fabric.
On an M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module NPIV proxy gateway, you cannot
apply an FCoE map is applied on fabric-facing FC ports and server-facing 10–Gigabit Ethernet ports.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN used for storage traffic, the
destination SAN fabric (FC-MAP value), FCF priority used by a server, and the FIP keepalive (FKA) advertisement
timeout.
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique. Use one FCoE map
to access one SAN fabric. You cannot use the same FCoE map to access different fabrics.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in Interface
configuration mode.
Related Commands
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
fka-adv-period
In an FCoE map, configure the time interval used to transmit FIP keepalive (FKA) advertisements.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive messages to peer devices.
The range is from 8 to 90 seconds.
Defaults 8 seconds
Command Modes FCOE MAP
Command History
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
1300 FC Flex IO Modules