Service Manual

Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-adv-erpiod command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
interface vlan (NPIV proxy gateway)
Create a dedicated VLAN to be used to send and receive Fibre Channel traffic over FCoE links between servers and a fabric over an M I/O
Aggregator and MXL 10/40GbE Switch with the FC Flex IO module NPIV proxy gateway.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.3.0.0 Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module configured as an NPIV proxy gateway.
Usage Information
FCoE storage traffic received from servers on an M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex
IO module NPIV proxy gateway is de-capsulated into Fibre Channel packets and forwarded over FC links to SAN
switches in a specified fabric. You must configure a separate FCoE VLAN for each fabric to which FCoE traffic is
forwarded. Any non-FCoE traffic sent on a dedicated FCoE VLAN will be dropped.
You configure the association between a dedicated VLAN, which carries FCoE traffic from server CNAs over the
NPIV proxy gateway to a SAN fabric in which destination storage arrays are installed, in an FCoE map by using the
fabric id vlan command.
When you apply an FCoE map to a server-facing Ethernet port, the port is automatically configured as a tagged
member of the FCoE VLAN.
For more information about VLANs and the commands to configure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
Example (Single
Range)
FTOS(conf)#interface vlan 10
FTOS(conf-if-vl-3)#
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
FC Flex IO Modules 1301