Service Manual

Parameters
access-list-name Enter a string up to 140 characters long as the access list name.
Defaults All access lists contain an implicit deny any; that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per
ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related Commands
ip access-list standard — configures a standard IP access list.
resequence access-list — Displays the current configuration.
permit (for Extended IP ACLs)
To pass IP packets meeting the filter criteria, configure a filter.
Syntax
permit {source mask | any | host ip-address} {destination mask | any | host ip-
address} [count [bytes]] [dscp value] [order] [fragments] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
•
Use the no deny {source mask | any | host ip-address} {destination mask | any |
host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the packet was
sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or hostname.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the filter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have
the lowest order by default (255).
Access Control Lists (ACL) 161