Service Manual
Related Commands
deny — configures a MAC ACL filter to drop packets.
seq — configure a MAC ACL filter with a specified sequence number.
seq
Configure a filter with a specific sequence number.
Syntax
seq sequence-number {deny | permit} {any | host mac-address | mac-source-
address mac-source-address-mask} {any | host mac-address | mac-destination-
address mac-destination-address-mask} [ethertype operator] [count [byte]]
Parameters
sequence-number Enter a number as the filter sequence number. The range is from zero (0) to 65535.
deny Enter the keyword deny to drop any traffic matching this filter.
permit Enter the keyword permit to forward any traffic matching this filter.
any Enter the keyword any to filter all packets.
host mac-address Enter the keyword host and then enter a MAC address to filter packets with that host
address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
mac-source-
address-mask
Specify which bits in the MAC address must be matched.
mac-destination-
address
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
ethertype operator (OPTIONAL) To filter based on protocol type, enter one of the following Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
• snap - is the IEEE 802.3 SNAP frame format.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Access Control Lists (ACL) 183