Service Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
route-map
Enable a route map statement and configure its action and sequence number. This command also places you in ROUTE-MAP mode.
Syntax
route-map map-name [permit | deny] [sequence-number]
Parameters
map-name Enter a text string of up to 140 characters to name the route map for easy identification.
permit (OPTIONAL) Enter the keyword permit to set the route map default as permit. If you
do not specify a keyword, the default is permit.
deny (OPTIONAL) Enter the keyword deny to set the route map default as deny.
sequence-number (OPTIONAL) Enter a number to identify the route map for editing and sequencing with
other route maps. You are prompted for a sequence number if there are multiple
instances of the route map. The range is from 1 to 65535.
Defaults Not configured.
If you do not define a keyword (permit or deny) for the route map, the permit action is the default.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module
Usage Information Use caution when you delete route maps because if you do not specify a sequence number, all route maps with
the same map-name are deleted when you use the no route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
194 Access Control Lists (ACL)