Service Manual

Enter the keyword vlan and then enter the VLAN ID to filter traffic associated with a
specific VLAN. The range is 1 to 4094 and 1 to 2094 for ExaScale ( you can use IDs 1 to
4094). To filter all VLAN traffic, specify VLAN 1.
ip-address
Enter an IP address in dotted decimal format (A.B.C.D) as the target IP address of
the ARP.
opcode code-number
Enter the keyword opcode and then enter the number of the ARP opcode. The range is
from 1 to 23.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower
order numbers have a higher priority) If you did not use the keyword order, the ACLs
have the lowest order by default (255).
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The time interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that
you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which
ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for flow-based monitoring on the MXL 10/40GbE Switch IO Module
platforms.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module platforms.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Added the support for the non-contiguous mask and the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
208 Access Control Lists (ACL)