Service Manual

neighbor route-reflector-client — configures a route reflector and clients.
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number} command.
Parameters
ip-address Enter an IP address as the route reflector cluster ID.
number Enter a route reflector cluster ID as a number from 1 to 4294967295.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When a BGP cluster contains only one route reflector, the cluster ID is the route reflector’s router ID. For
redundancy, a BGP cluster may contain two or more route reflectors. Assign a cluster ID with the bgp
cluster-id command. Without a cluster ID, the route reflector cannot recognize route updates from the other
route reflectors within the cluster.
The default format for displaying the cluster-id is dotted decimal, but if you enter the cluster-id as an integer, it is
displayed as an integer.
Related Commands
bgp client-to-client reflection — enables route reflection between the route reflector and clients.
neighbor route-reflector-client — configures a route reflector and clients.
show ip bgp cluster-list — views paths with a cluster ID.
bgp confederation identifier
Configure an identifier for a BGP confederation.
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation identifier as-number
command.
Parameters
as-number Enter the AS number. The range is from 0 to 65535 (2 byte), from 1 to 4294967295 (4
byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not configured.
Border Gateway Protocol IPv4 (BGPv4) 283