Service Manual
To remove the route map, use the no neighbor {ip-address | peer-group-name} route-map
map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you apply a route map to outbound routes, only routes that match at least one section of the route map are
permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used
in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound
policies on that peer.
neighbor route-reflector-client
Configure the router as a route reflector and the specified neighbors as members of the cluster.
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To remove one or more neighbors from a cluster, use the no neighbor {ip-address | peer-group-
name} route-reflector-client command. If you delete all members of a cluster, you also delete the
route-reflector configuration on the router.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGP
312 Border Gateway Protocol IPv4 (BGPv4)