Service Manual

• set tag
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The system software resolves the network address the network command configures with the routes in the
main routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.
Related Commands redistribute — redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Although the system does not generate a route due to the backdoor config, there is an option for injecting/
sourcing a local route in the presence of network backdoor config on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Border Gateway Protocol IPv4 (BGPv4) 317