Service Manual

vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN dual
QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.
Openflow number Enter the keyword openflow and then the number of FP blocks for open flow
(multiples of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 6.
Iscsioptacl number Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos number, l2pt
number ipmacacl
number ecfmacl
number [vman-qos
| vman--qos-dual
number | vman-
qos-dual-fp
number] ipv4pbr
number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The total
space allocated must equal 13. The range for ipv4acl is from 1 to 4. The ipv6acl range
must be a factor of 2.
The total space allocated must equal 13.
The range for ipv4acl is 1 to 4.
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a multiple of 4.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword nlbcluster ACL.
9.4.(0.0) Added support for PBR.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system
for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks cannot be
reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
On the switch, there can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in
factors of two. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of
6+4+2+1 Blocks is supported.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of two (2, 4, 6, 8, 10).
358 Content Addressable Memory (CAM)