Service Manual

To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command Modes PROTOCOL LLDP
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command Modes PROTOCOL LLDP
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
priority
Configure the priority for the PFC threshold to be allocated to the buffer space parameters.
Syntax
priority value buffer-size size pause-threshold threshold-value resume-offset
threshold-value shared-threshold-weight size
Parameters
priority Specify the priority of the queue for which the buffer space settings apply
value Enter a number in the range of 0 to 7 to denote the priority to be allocated to the
dynamic buffer control mechanism
buffer-size Ingress buffer size
size Size of the ingress buffer in KB. Enter a number in the range of 0 to 7787. The default is
45 KB.
pause-threshold Buffer limit for pause frames to be sent
Data Center Bridging (DCB) 373