Service Manual
Usage Information
NOTE: Please note that Dell Networking does not recommended to use this command as it has been
deprecated in the current 9.4(0.0) release. A warning message appears when you try to run this
command indicating that you have to use the dcb-map commands in the future.
Example
Dell#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2
show stack-unit stack-ports ets details
Displays the ETS configuration applied to egress traffic on stacked ports, including ETS Operational mode on each unit and the
configurated priority groups with dot1p priorities, bandwidth allocation, and scheduler type.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-number} ets details
Parameters
stack-unit Enter the stack unit identification.
port-number Enter the port number.
Command Modes CONFIGURATION
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)# show stack-unit all stack-ports all ets details
Stack unit 0 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
--------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,3,4,5,6,7 100% ETS
1 - -
2 - -
3 - -
4 - -
5 - -
6 - -
7 - -
8 - -
Stack unit 1 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
--------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,3,4,5,6,7 100% ETS
1 - -
2 - -
388
Data Center Bridging (DCB)