Service Manual

• Commands to Configure Secure DHCP
• arp inspection
• arp inspection-trust
• clear ip dhcp snooping
• clear ipv6 dhcp snooping binding
• ip dhcp snooping
• ipv6 dhcp snooping
• ip dhcp snooping database
• ipv6 dhcp snooping database write-delay
• ip dhcp snooping binding
• IPv6 DHCP Snooping Binding
• ip dhcp snooping database renew
• ipv6 dhcp snooping database renew
• ip dhcp snooping trust
• ipv6 dhcp snooping trust
• ip dhcp source-address-validation
• ip dhcp snooping vlan
• ipv6 dhcp snooping vlan
• ip dhcp relay
• ip dhcp relay secondary-subnet
• show ip dhcp snooping
• show ipv6 DHCP snooping
• ip dhcp snooping verify mac-address
• ipv6 DHCP snooping verify mac-address
Commands to Configure the System to be a DHCP
Server
To configure the system to be a DHCP server, use the following commands.
clear ip dhcp
Reset the DHCP counters.
Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
binding Enter the keyword binding to delete all entries in the binding table.
address Enter the IP address to clear the binding entry for a single IP address.
conflicts Enter the keyword conflicts to delete all of the log entries created for IP address
conflicts.
server statistics Enter the keywords server statistics to clear all the server counter information.
Defaults none
Command Modes EXEC Privilege
Dynamic Host Configuration Protocol (DHCP) 423