Service Manual

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Entering <CR> after the clear ip dhcp binding command clears all the IPs from the binding table.
debug ip dhcp server
Display the Dell Networking OS debugging messages for DHCP.
Syntax
debug ip dhcp server [events | packets]
Parameters
events Enter the keyword events to display the DHCP state changes.
packet Enter the keyword packet to display packet transmission/reception.
Defaults none
Command Modes EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
debug ipv6 dhcp
To enable debug logs for DHCPv6 relay agent transactions.
Syntax
debug ipv6 dhcp
To disable the debug logs for DHCPv6 relay agent transactions, use the debug ipv6 dhcp command.
Defaults none
Command Modes EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
default-router
Assign a default gateway to clients based on the address pool.
Syntax
default-router address [address2...address8]
424 Dynamic Host Configuration Protocol (DHCP)