Service Manual

To delete a zoneset, use the no fc zoneset zoneset_name [member] command.
Parameters
zoneset_namemem
ber
Enter the zoneset name.
Enter the WWPN, FC-ID, or Alias name.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
9.1(1.0) Introduced on the S5000.
Example
Dell(conf)#fc zoneset test1
Dell(conf-fc-zoneset-test1)#member ?
WORD Zone Name
Dell(conf-fc-zoneset-test1)#member
Related Commands
show fc zoneset — displays the configured and active zoneset.
show fcoe-map — displays the fabric parameters.
fcoe-map
Create an FCoE map which contains the parameters used to configure the links between server CNAs and a SAN fabric. Apply the FCoE
map on a server-facing Ethernet port.
Syntax
fcoe-map map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes CONFIGURATION
INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
9.0(1.3) Introduced on the S5000.
Usage Information
An FCoE map is a template to map FCoE and FC parameters in a converged fabric. An FCoE map virtualizes
upstream FC ports on an NPIV proxy gateway to appear to downstream server CNA ports as FCoE forwarder
(FCF) ports on an FCoE network. When applied to FC and Ethernet ports on an NPIV proxy gateway, an FCoE
map allows the switch to operate as an FCoE-FC bridge between an FC SAN and an FCoE network. It provides
necessary parameters to FCoE-enabled servers and switches to log in to a SAN fabric.
456 FC FLEXIO FPORT