Service Manual

2 Enter the interface command and then enter an interface type and interface number that is available on the switch.

The prompt changes to include the designated interface and slot/port number. For example:

Prompt Interface Type

Dell(conf-if)#

INTERFACE mode

Dell(conf-if-

te-0/0)#

Ten-Gigabit Ethernet interface then slot/port information

Dell(conf-if-

fo-0/0)#

Forty-Gigabit Ethernet interface then slot/port information

Dell(conf-if-

lo-0)#

Loopback interface number

Dell(conf-if-

nu-0)#

Null Interface then zero

Dell(conf-if-

po-0)#

Port-channel interface number

Dell(conf-if-

vl-0)#

VLAN Interface then VLAN number (range 1–4094)

Dell(conf-if-

ma-0/0)#

Management Ethernet interface then slot/port information

Dell(conf-if-

range)#

Designated interface range (used for bulk configuration).

IP ACCESS LIST Mode

To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list

standard or ip access-list extended command.

To enter IP ACCESS LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The prompt

changes to include (conf-std-nacl) or (conf-ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

LINE Mode

To configure the console or virtual terminal parameters, use LINE mode.

To enter LINE mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the line command. Include the keywords console or vty and their line number available on the switch. The prompt

changes to include (

config-line-console) or (config-line-vty).

You can exit this mode by using the exit command.

CLI Basics