Service Manual

MAC ACCESS LIST Mode

To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the mac access-list

standard or mac access-list extended command.

To enter MAC ACCESS LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

Use the mac access-list standard or mac access-list extended command. Include a name for the ACL. The prompt

changes to include (conf-std-macl) or (conf-ext-macl).

You can return to CONFIGURATION mode by using the exit command.

MULTIPLE SPANNING TREE Mode

To enable and configure the multiple spanning tree protocol (MSTP), use MULTIPLE SPANNING TREE mode , as described in Multiple

Spanning Tree Protocol (MSTP).

To enter MULTIPLE SPANNING TREE mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol spanning-tree mstp command.

You can return to CONFIGURATION mode by using the exit command.

Per-VLAN SPANNING TREE (PVST+) Plus Mode

To enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, refer to Per-VLAN

Spanning Tree Plus (PVST+).

NOTE

: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.

To enter PVST+ mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-pvst).

You can return to CONFIGURATION mode by using the exit command.

PREFIX-LIST Mode

To configure a prefix list, use PREFIX-LIST mode.

To enter PREFIX-LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to include (conf-nprefixl).

You can return to CONFIGURATION mode by using the exit command.

CLI Basics